Installation Guide

17
TOOLS YOU MAY NEED
Installation Ref r i g er a t o r
Instructions
Quest ions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit our Website at: www.GEAppliances.ca
BEFORE YOU BEGIN
Re ad t h e s e i ns t r u c t i o n s com pl e t e l y a n d c a r e f ul l y .
•
IMPORTANT ³ Observe all governing codes
and ordinances. Save these instructions for local
inspector’s use.
•
Note to Installer – Be sure to leave these instructions
with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
20 minutes
W a t e r L i n e I n s t a l l a t i o n
30 minutes
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
PREPARATION
MOVING THE REFRIGERATOR INDOORS
If the refrigerator will not fit through a doorway, the
refrigerator door and freezer drawer or door can be
removed.
• To remove the refrigerator door, see Step 1 in the
Re v e r s ing t he D o o r Sw i n g section.
• To remove the freezer drawer, see the Re mo vi ng t h e
Fr eezer Dr a w er section.
WATER SUPPLY TO THE ICE MAKER AND DISPENSER
If the refrigerator has an ice maker, it will have to be
connected to a cold water line. A GE water supply kit
(co nt ai ni ng t ub in g, sh ut of f va lv e, f i t t i ng s a nd in st r uc t i on s)
is available at extra cost from your dealer, by visiting our
website at GEAp p li a n c es.co m (in Canada at
www.GEAppliances.ca) o r f r o m Par t s an d Ac cessor i es,
800.626.2002 (in Canada 1.800.661.1616).
Adjust able Wrench
1/4” Outer Diameter
Co m p r e ssi o n Nu t
and Ferrule (sleeve)
(ice m aker m od el s only)
Ph il l ip s- Hea d Sc r ew d r i ver
Ȓµ and ȓµSo c k e t
Ra t c h et / D r i ve r
3/32”, 1/8” & 3/16” Allen
Wrenches
Pen c il
1/8” Drill Bit and
El e c t r i c o r H a n d D r i l l
Ta pe Mea su r e
1/4” Nut Driver
Wire Cutters
Level
To r x T20 , Dr i ver