Specifications

For answers to your Monogram, GE Café

™

Series, GE Profile

™

Series or

GE Appliances product questions, visit our website at geappliances.com

or call GE Answer Center

Service, 800.626.2000.

GFD40GSCMWW

7.0 Cu. Ft. Capacity Frontload Dryer

Specification Revised 3/18

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)

EXHAUST OPTIONS: 3-way via rear, left, and

bottom.

CIRCUIT REQUIREMENTS: An individual,

properly grounded branch circuit, protected by a

15-20 amp circuit breaker or a time-delay fuse, is

required.

NOTE: Dryer wall outlet must be located within

36" of service cord entry and accessible when dryer

is mounted in position.

INSTALLATION INFORMATION: For complete

information, see installation instructions packed

with your dryer.

GAS DRYER RATING

120V 60Hz, 6A

27"

32 1/5"

39 3/10"

4 3/8"

5 3/8"

PAGE 1
GFD40GSCMWW GE® 7.0 Cu. Ft. Capacity Frontload Dryer DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES) GAS DRYER RATING 120V 60Hz, 6A 27" 32 1/5" EXHAUST OPTIONS: 3-way via rear, left, and bottom. CIRCUIT REQUIREMENTS: An individual, properly grounded branch circuit, protected by a 15-20 amp circuit breaker or a time-delay fuse, is required. NOTE: Dryer wall outlet must be located within 36" of service cord entry and accessible when dryer is mounted in position.
PAGE 2
GFD40GSCMWW GE® 7.0 Cu. Ft. Capacity Frontload Dryer SPECIAL INSTALLATION REQUIREMENTS STACKED INSTALLATION: Brackets for stacking dryer over washer are not included with the washer. Order part no. GEFLSTACK or part no. WE25X10018. STACKED DIMENSIONS (IN INCHES) 50-5/8 24-7/8 3-1/2 3 ALCOVE OR CLOSET INSTALLATION: If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back. The dryer MUST be exhausted to the outside.
PAGE 3
GE Dryer Vent GE Dryer Vent GFD40GSCMWW GE® 7.0 Cu. Ft. Capacity Frontload Dryer DRYER EXHAUSTING INFORMATION – METAL DUCT ONLY For complete information, see installation instructions packed with your dryer. DUCTING MATERIALS: For best performance, this dryer should be vented with 4” diameter all rigid metal exhaust duct. If rigid metal duct cannot be used, then UL-listed flexible metal (semi-rigid) ducting can be used (Kit WX08X10077).
PAGE 4
GFD40GSCMWW GE® 7.0 Cu. Ft.