Quick Specs

ManualsBrandsGE Appliances ManualsAppliancesGSM2200VWW Spacemaker® 24" Under-the-Sink Dishwasher - White

For answers to your Monogram, GE Café

™

Series, GE Profile

™

Series or

GE Appliances product questions, visit our website at geappliances.com

or call GE Answer Center

Service, 800.626.2000.

Specification Revised 4/20

Listed by

Underwriters

Laboratories

NOTE: Undersink dishwashers can be installed only under sinks

and not under other appliances.

PLUMBING—HOT WATER ONLY: Use 3/8" O.D. copper tubing

or 1/2" O.D. plastic tubing minimum inlet line. Water valve has

3/8" internal threads. Hand cut-off valve is recommended.

ELECTRICAL: Fuse circuit with 15 amp or 20 amp standard fuse

or circuit breaker. Total amp load is 8.6. Dishwasher operates on

120V, 60HZ power, Two-wire cable (14 Ga. Min.) with ground must

be installed.

SPECIFICATIONS: Inlet water temperature recommended—

minimum 120°F at dishwasher. Inlet water pressure required—15

to 120 lbs./sq. inch.

NOTE: All rough-in, both plumbing and electrical, must be

completed before the dishwasher is installed. All plumbing and

electrical work must be in accordance with local codes.

Spacemaker Dishwasher Dimensions

(Pub. 1-G003 pg. 132B) May 12, 1993

2" From

cabinet

2" From

floor

19" From

wall

Cable 24"

from wall

White (neutral)

Black (line)

Ground

Plumbing and

wiring must enter

within this area

from either side,

rear or bottom

DW PLUMBING/ELECTRICAL

ROUGH-IN (IN INCHES)

FRONT VIEW

Hot

Cold

GSM2200V

GE Spacemaker

Under-the-Sink Dishwasher

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)

Summary of content (4 pages)

PAGE 1
Spacemaker Dishwasher Dimensions (Pub. 1-G003 pg. 132B) May 12, 1993 GSM2200V GE Spacemaker Under-the-Sink Dishwasher ® DW PLUMBING/ELECTRICAL ROUGH-IN (IN INCHES) DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES) NOTE: Undersink dishwashers can be installed only under sinks and not under other appliances. PLUMBING—HOT WATER ONLY: Use 3/8" O.D. copper tubing or 1/2" O.D. plastic tubing minimum inlet line. Water valve has 3/8" internal threads. Hand cut-off valve is recommended.
PAGE 2
dishwasher drain 12" From wall 6 GSM2200V 10" from cabinet GE Spacemaker® Under-the-Sink Dishwasher NOTE: A close-fitting elbow or special shallow sink strainer is necessary to provide clearance between sink drain and dishwasher. Dishwasher furnished with 1/2" I.D. drain hose, 78" long. If using copper tubing, 2" length of 1/2" I.D. rubber hose must be provided to connect copper tubing to pump outlet. Disposer should have 7/8" I.D. dishwasher drain connector.
PAGE 3
GSM2200V GE Spacemaker® Under-the-Sink Dishwasher CABINET ROUGH-IN NOTE: Either single- or double-bowl sink may be used, centered or offset, as shown in the front view illustration. CABINET ROUGH-IN DIMENSIONS (IN INCHES) The 20-1/2" maximum dimension from wall to front of sink bowl must be accurate if dishwasher is to fit properly under sink. Water lines to sink faucet and drain from sink can be run through area “A.” HOT WATER line to dishwasher is installed in area “B.
PAGE 4
GSM2200V GE Spacemaker® Under-the-Sink Dishwasher FEATURES AND BENEFITS Spacemaker® upper rack – Maximizes space without losing cabinets Two-stage filtration with Extra Fine filter – Extra filtration keeps water clean Piranha™ hard-food disposer – Grinds food into small particles that are washed away Hot Start option – Provides optimal water temperature for dependable performance 64 dBA – Motor runs quietly to keep kitchen peaceful Model GSM2200VWW – White on white Model GSM2200VBB – Black on black Model: