Quick Start Guide

JP3030SJ
GE
®
30" Built-In Knob Control Electric Cooktop
Specification Created 1/15
Listed by
Underwriters
Laboratories
To insure accuracy, it is best to make a
template when cutting the opening in the counter
Electrical junction box 16" MIN.
below countertop
Cooktop
29-7/8"
21-1/2"
19-1/4"
28"
19-5/8" to
19-3/4"
28-1/2" to
28-5/8"
JP3530SJ, JP3030SJ
2-1/2" MIN.
Required
1-3/4" MIN.
to rear wall
13" MAX. depth of unprotected
overhead cabinets (when no
hood or microwave is installed)
30" MIN. from countertop to
unprotected cabinet (when
no hood or microwave is
installed)
15" MIN. height from countertop
to nearest cabinet (including
light rails) on both sides of
cooktop
2" MIN. clearance
to side wall from cut-out
on left sides of unit and
1-1/2" clearance on
right side of unit
3-1/4" at front of unit and
4-3/16" at conduit
location
Important: Requires a 5" free area between
the bottom of the cooktop to any combustible
material, i.e., shelving. Free area not required
when installing wall oven underneath cooktop.
Refer to installation instructions. Requires a 15"
minimum from cooktop to adjacent overhead
cabinets. Units are furnished with a 48" flexible
armored cable.
note: 30" Ribbon cooktops are approved for use
over select GE 27" and GE 30" Single Wall Ovens
and Warming Drawers. Refer to cooktop and wall
oven/warming drawer installation instructions
packed with product for current dimensional
data. If installed with a GE Telescopic Downdraft
System, consult both the cooktop and downdraft
installation instructions packed with product
before installing. Cooktop gas/electric supply
may need to be re-routed to install downdraft.
The countertop cutout requires 23-1/2" minimum
flat countertop surface and 25" minimum total
countertop depth. In addition, other clearances to
front edge of the countertop must be considered.
Before installing, consult installation instructions
packed with product for current dimensional data.
Cutout fIller trIm kIt: A filler trim kit
is available for use if your countertop cutout is
larger than the dimension shown, up to 29-13/16" x
20-7/16". Order JXTR32B for black or JXTR32W
for white, to reduce the cutout opening for
installation of this cooktop. These kits may be
ordered from your GE Dealer.
DImensIons anD InstallatIon InformatIon (In InChes)
KW Rating
240V 7.4
208V 6.4
Amperage
240V 30.8 Amps†
208V 30.8 Amps†
†
Note: Check local codes for required breaker size
approxImate CookIng DImensIons
For answers to your Monogram,
®
GE Profile
™
or GE
®
appliance questions, visit our website
at geappliances.com or call GE Answer Center
®
service, 800.626.2000.