Installation Guide
IMPORTANT SAFETY INSTRUCTIONS
3
Installation Instructions
A qualified electrician must perform a ground continuity 
check on the wall receptacle before beginning the 
installation to ensure that the outlet box is properly 
grounded. If not properly grounded, or if the wall 
receptacle does not meet electrical requirements noted 
(under ELECTRICAL REQUIREMENTS), a qualified electrician 
should be employed to correct any deficiencies.
WARNING
Risk of Electric Shock. 
Can cause injury or death: 
Remove house fuse or 
open circuit breaker before 
beginning installation to avoid 
severe or fatal shock injury.
WARNING
Risk of Electric Shock. 
Can cause injury or death: THIS 
APPLIANCE MUST BE PROPERLY 
GROUNDED to avoid severe or 
fatal shock.
The power cord of this 
appliance is equipped with 
a three-prong (grounding) 
plug which mates with 
a standard three-prong 
(grounding) wall receptacle 
to minimize the possibility 
of electric shock hazard 
from this appliance.
Where a standard two-prong wall receptacle is 
encountered, it must be replaced with a properly grounded 
three-prong wall receptacle, installed by a qualified 
electrician.
WARNING
Risk of Electric Shock. 
Can cause injury or death: DO NOT, under any 
circumstances, cut, deform or remove any of the prongs 
from the power cord. Do not use with an extension cord. 
Failure to comply may cause fire.
Ensure proper 
ground exists 
before use
CAUTION
 For personal safety, 
the mounting surface must be capable of supporting 
the cabinet load, in addition to the added weight of this 
63–85 pound product, plus additional oven loads of up 
to 50 pounds or a total weight of 113–135 pounds.
CAUTION
For personal safety, this product 
cannot be installed in cabinet arrangements such as an 
island or a peninsula. It must be mounted to BOTH a top 
cabinet AND a wall.
CAUTION
 To avoid the risk of personal injury 
(back injury or other injuries due to excessive weight of 
the microwave oven) or property damage, you will need 
two people to install this microwave oven.
ELECTRICAL 
REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz, 15 amps and 
1.7 kilowatts. This product must be connected to a 
supply circuit of the proper voltage and frequency. Wire 
size must conform to the requirements of the National 
Electrical Code or the prevailing local code for this 
kilowatt rating. The power supply cord and plug should 
be brought to a separate 15- to 20-ampere branch 
circuit single grounded outlet. The outlet box should 
be located in the cabinet above the microwave oven. 
The outlet box and supply circuit should be installed 
by a qualified electrician and conform to the National 
Electrical Code or the prevailing local code.
 This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety 
messages will follow the safety alert symbol and the word “DANGER”, “WARNING”, or “CAUTION”. These words are defined as:
     Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
     Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
     Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
WARNING
DANGER
CAUTION










