Installation Instructions

Table Of Contents

8 31-7000091 Rev. 1

DETERMINING MOUNTING PLATE LOCATION UNDER YOUR CABINET

Plate Position – beneath flat bottom

cabinet

Plate Position – beneath framed

recessed cabinet bottom

Draw a vertical line on the wall at the center of the

30” space.

Tape the Rear Wall Template onto the wall

matching the centerline and touching the bottom

cabinet frame.

30” to Cooktop

Plate Position – beneath recessed

bottom cabinet with front overhang.

30” to Cooktop

Draw a line on the

back wall equal to

the depth of the front

overhang

Your cabinets may have decorative trim that interferes

with the microwave installation. Remove the decorative

trim to install the microwave properly and to make it

level.

THE MICROWAVE MUST BE LEVEL

Use a level to make sure the cabinet bottom is level.

If the cabinets have a front overhang only, with no

back or side frame, install the mounting plate down the

same distance as the front overhang depth. This will

keep the microwave level.

Measure the inside depth of the front overhang.

Draw a horizontal line on the back wall an equal

distance below the cabinet bottom as the inside

depth of the front overhang.

For this type of installation with front overhang only,

align the Rearwall Template with this horizontal

line, not touching the cabinet bottom as described

in Step D.

Draw a vertical line on the wall at the center of the

30” wide space. Tape the Rear Wall Template onto

the wall matching the centerline and touching the

bottom of the cabinet