Installation Sheet

ManualsBrandsGE Appliances ManualsShop All GEGE 15" Cabinet Bump Out Kit for Over the Range Microwave Ovens

Installation Bump-Out Kit

Instructions

JX15BUMP

For 15” Deep Cabinets

49-40719-1 03-15 GE

IMPORTANT:

Use the existing mounting bracket that comes with your OTR Microwave to identify location for the Bump Out Kit.

Place the original bracket on the wall according to

installation instructions from the OTR Microwave to

determine where to place the Bump Out Kit Bracket.

Mark lowest edage of bracket

Existing Mounting Bracket

from OTR Microwave

Place the Bump Out Kit Bracet in place of existing bracket location making sure that the bottom edge lines up.

Bump-Out Kit

Bracket

Summary of content (4 pages)

PAGE 1
Installation Instructions Bump-Out Kit JX15BUMP For 15” Deep Cabinets IMPORTANT: Use the existing mounting bracket that comes with your OTR Microwave to identify location for the Bump Out Kit. Place the original bracket on the wall according to installation instructions from the OTR Microwave to determine where to place the Bump Out Kit Bracket.
PAGE 2
Installation Instructions TOOLS YOU WILL NEED #1 and #2 Phillips screwdriver Tin snips (for cutting damper, if required) Ruler or tape measure and straight edge Pencil Scissors (to cut template, if necessary) Electric drill with 3ø16” , 7ø16”, 3ø8”, 1ø2” and 5ø8” drill bits Gloves Saw (saber, hole or keyhole) Carpenter square (optional) Filler blocks or scrap wood pieces, if needed for top cabinet spacing (used on recessed bottom cabinet installations only) Stud finder or Hammer (optional) Safety
PAGE 3
Installation Instructions 1 PLACEMENT OF THE BUMP-OUT BRACKET A. FINDING THE WALL STUDS 1 Find the studs, using one of the following methods: A. Stud finder – a magnetic device which locates nails. OR B. Use a hammer to tap lightly across the mounting surface to find a solid sound. This will indicate a stud location. 2 After locating the stud(s), find the center by probing the wall with a small nail to find the edges of the stud. Then place a mark halfway between the edges.
PAGE 4
Installation Instructions 2 INSTALLING THE BUMP-OUT BRACKET A. ATTACH THE MOUNTING PLATE TO THE WALL To use toggle bolts: Mounting Plate Spacing for Toggles More Than Wall Thickness Toggle Wings Toggle Bolt Wall Bolt End 3 Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate.