Installation Instructions

6 31-7000092 Rev. 1
Installation Instructions
TOOLS YOU WILL NEED
#1 and #2
Phillips
screwdriver
Pencil
Ruler or tape measure and
straight edge
Carpenter square
(optional)
Tin snips (for cutting
damper, if required)
Electric drill with
3
⁄16″,
7
⁄16″,
1
⁄2″and
5
⁄8″drillbits
Hammer (optional)
Stud
finder
Filler blocks or scrap
wood pieces, if needed
for top cabinet spacing
(used on recessed
bottom cabinet
installations only)
Gloves
Saw (saber, hole or keyhole)
Level
Duct and masking
tape
Scissors (to cut
template, if necessary)
Safety goggles
MOUNTING SPACE
NOTES:
•Thespacebetweenthecabinetsmustbe30″wide
and free of obstructions.
• This oven is for installation over ranges up to
36″wide.
• If the space between the cabinets is greater than
30”, a Filler Panel Kit may be used to fill in the gap
between the microwave oven and the cabinets. Your
Owner’s Manual contains the kit number for your
model.
• If you are going to vent your oven to the outside, see
Hood Exhaust Section for exhaust duct preparation.
• When installing the oven beneath smooth, flat
cabinets, be careful to follow the instructions on the
top cabinet template for power cord clearance.
• * 13” max: for standard installation, 15” cabinet
depth requires additional steps using an additional
installation kit JX15BUMPWW/BB.
• For models with top venting holes: Do not allow
cabinetry or other objects to block the airflow of the vent.
• Café branded over-the-range microwaves should only
be installed over Café branded ranges. Installation over
any other range may result in surface temperatures that
can cause burns.
• All other over-the-range microwaves should not be
installed over any cooktop or range with a combined
BTU greater than 60,000 BTU.
Backsplash
66″ormore
from the floor
to the top of
the oven
30″
2″
30″
min.
16-
1
⁄2″
Bottom edge of
cabinet needs
tobe30″or
more from the
cooking surface
*13″max.