GE Installation Manual

31-5000490 Rev. 0 03-20 GEA
Installation Instructions
for your new
Before you begin - Read these instructions completely and carefully.
IMPORTANT – OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer – Be sure to leave these instructions with the Consumer.
Note to Consumer – Keep these instructions with your Owner’s Manual for future reference.
RAG13A
Rear Grille
Tools Needed
• 1/4” Nut Driver
Pliers
Prepare the wall case for
installation of grille:
1. Remove the indoor protective cover from the wall
case, if present.
2. Remove the outdoor protective cover from the wall
case, if present. Remove the cover from inside the
cabinet following the instructions on the cover.
3. If the air conditioner is already installed in the wall
case, turn off the air conditioner, unplug the unit,
and slide the unit out of the case.
CAUTION
Risk of injury or property damage.
To prevent the grille from falling, hold onto the
ribbon on the grille. If there is no ribbon present,
use pliers and wear gloves to hold the grille.
4. To remove an already installed grille, remove the
two screws at the bottom edge of the grille. Slide
down one inch to free the top edge.
Parts Included
• Grille
“S” clips (2)
Screws (2)
NOTE:
The grille can be installed from the inside after the
cabinet is installed.

Summary of content (4 pages)