GE Installation Manual

2
Installation Instructions
Installatation of new grille
(for wall cases with external grille. Wall case
models: RAB46A, RAB47A, RAB48A, RAB26A, and
RAB26W)
1. Make sure that the grille edge facing up has two
tabs sticking up.
2. Using the ribbon to hold the grille, place the grille
completely through the cabinet so that it is outside.
Angle the grille so that the top edge is against the
top flange of the wall case.
Slot Location
Insert tabs on top of the grille into two slots on
the top rear flange. Make sure that both tabs are
through the slots and visible inside the case.
3. Line up the two plastic grommets in the bottom of
the grille with holes in the bottom rear flange of the
case. Secure with the two included screws from the
inside.
Screws
4. Remove the ribbon from the grille.
Installatation of new grille
(for wall cases with a recessed grille. Wall case
models: RAB20, RAB46, RAB47, and RAB48)
1. Use the pliers to bend back the two tabs on the top
edge of the grille.
2. Install the “S” clips on the top rear flange of the
case approximately 8 inches from each side. Clips
fit through the hole in the flange.
8”
8”
S-CLIP
3. Using the ribbon, place the grille completely through
the cabinet so that it is outside. Then pull back
against the rear of the cabinet and insert the top of
the grille up into the clips.
4. Line up the two plastic grommets in the bottom of
the grille with holes in the bottom rear flange of the
case. Secure with the two included screws from the
inside.
Screws
5. Remove ribbon from the grille.