Installation Guide

REMOVE THE REFRIGERATOR DOORS (cont)

Disconnect the water line from the back of the unit by

pressing down on the dark grey collar while pulling up

on the water line.

Pull waterline through case conduit from the top to free

the line for door removal. The water line is more than 4’

long and may need to be taped to Door for accessibility

when reinstalling.

Using a 3/8” socket ratchet/driver, remove the screws

securing the top hinge to the cabinet,

then lift the hinge straight up to free the hinge pin from

the location in the top of the door.

CAUTION

Lifting Hazard.

Single person lift could cause injury. Use assistance

when handling, moving or lifting the refrigerator doors.

Note: when removing door, to prevent damage to door

and electronics, carefully place the door in a proper

location.

Note: The lower door hinge pin and hinge are keyed and

must be matched correctly for the door to self close

properly. Please follow the directions carefully.

REMOVE THE REFRIGERATOR DOORS

Securely tape the door shut with masking tape or have

a second person support the door.

Start with left-hand door first: Remove the hinge cover

on top of the left refrigerator door by removing all hex

screws and pulling it up. Do the same for the

right-hand door and the middle cover.

Disconnect both electrical connectors at the top cover.

Remove the 1/4” hex head screw to disconnect the

ground wire from the hinge.

Remove the 1/4” hex head screw to remove the strain

relief from the water line.

Installation Instructions

INSTALLING THE REFRIGERATOR (cont.)

Ground

screw

Strain

Relief

Hinge

Cover