Owners manual

49-60820 27
INSTALLATION INSTRUCTIONS
REINSTALLING THE
REFRIGERATOR DOORS
Reverse steps 1 through 4 to reinstall refrigerator,
follow details below for critical alignments.
Reinstall center hinge
first and torque the
screws to 65 in-lb (7.34
N-m). With the LH door
at 90º to the front of the
case, lower the refrigerator
door onto the center hinge.
Ensure that the door and hinge align correctly.
Rotate doors closed and make sure moveable
center sealing portion of the door aligns with
the striker. If the door will not self-close after
reinstalling, remove door, turn door upside down,
FKHFNDOLJQPHQWPDUNDQGDUURZWKHUHLVDQ
alignment mark on the door closure mechanism It
corresponds to an alignment mark on the bottom
end cap. Rotate door closure mechanism to align
mark and arrow, reinstall door).
Securely tape the door shut with masking tape
or have a second person support the door.
Reinstall the top hinge and torque the screws to
65 in-lb (7.34 N-m).
Be sure to reinstall the ground wire and strain relief
to the top hinge.
Reinstall the hinge cover. NOTE: Ensure wires
are not pinched or under screw bosses before
tightening screws.
REMOVE THE REFRIGERATOR
DOORS (cont)
NOTE: for proper installation later, please follow
the next step carefully.
Fresh Food doors to be REMOVED and
INSTALLED opened at 90° with case front.
REMOVE OPPOSITE DOOR
Follow the same procedure on the opposite
door. There are no wires or water lines on the
opposite side
REMOVE CENTER HINGE
(if necessary)
5HPRYHWKHƎVFUHZVVHFXULQJWKHFHQWHUKLQJHWR
WKHFDELQHW8VH7GULYHUWRUHPRYHRXWERDUGVFUHZ
F
Lift up & off
center hinge
Open Door to
90°
4
A
5
B
Loosen Outer screws
Remove
center screw
C
align marks
8QGHUVLGHRI)UHVK)RRG'RRU
If door cannot be installed at 90° follow steps below:
1. If space or model limits opening door to less than 180°, then:
a) Remove door, carefully turn door upside down.
b) Check alignment of door closure mechanism shaft on
underside of door. The flats on the shaft should
correspond to alignment tab on plastic ring or mark
on bottom end cap.
F,IVKDIWLVQRWDOLJQHGWRWDEPDUNXVLQJ´$OOHQ
wrench, rotate door closure mechanism shaft
counterclockwise for right door and clockwise for left
door. Then align flat with tab/mark.
d) Install the door at 90°.
D
3
Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)