Owners manual

42 49-60820
Truth or Myth? Answer Explanation
The refrigerator water filter may require
replacement prior to six months of use
758( The water filter indicator will indicate the need to replace the
water filter every six months or 170 gallons (643.52 liters) of
water dispensed (select models only). Water quality varies
from city to city. If water flow from the dispenser slows, or ice
production decreases, the water filter should be replaced,
even though the filter indicator may not indicate the need for
replacement.
The automatic ice maker in my
refrigerator will produce ice when the
refrigerator is plugged in to a power
receptacle.
MYTH The refrigerator must be connected to water, and the ice
maker must be turned on. Make sure the ice maker is turned
on, only after the water line is connected and water is turned
on. The ice maker can be turned on/off from the controls and
ensure the ice maker is on, as indicated on the refrigerator
control panel. See Automatic Ice Maker section.
After the refrigerator has been plugged
in and connected to water, I will
immediately have unlimited chilled water
available from the water dispenser.
MYTH The water dispenser tank located inside the refrigerator stores
water for dispensing. The water in this tank requires 24 hours
to chill after installation. High usage conditions will not allow
time for the water to chill.
After water dispenses, a few drops of
water are normal.
758( A few drops of water may fall from the dispenser, after the
dispenser paddle has been released. To minimize the drops,
remove the glass slowly from the dispenser.
I will never see frost inside the freezer
compartment.
MYTH Frost inside the freezer typically indicates that the door is
not properly sealed, or has been left open. If frost is found,
clear the frost using a plastic spatula and towel, then check
to ensure that no food packages or containers are preventing
the freezer door from closing. Check the refrigerator control
panel to ensure the door alarm is on.
Before you schedule service, review the detailed troubleshooting tips in the Owner’s manual. If
needed, service can be scheduled by visiting us online at cafeappliances.com/service.
In Canada, visit cafeappliances.ca/service
Truth or Myth
SERVICE
Problem Possible Causes What to Do
Delay when using Keurig K-cup Pod
dispenser
To ensure a quality beverage is
delivered, a short delay is required
to ensure the refrigerator is
operating correctly
Ensuring consistent, quality operation
requires the refrigerator to delay
dispense for a short period of time
After brewing, my powdered
beverage is not fully cleared from
the used pod
Depending on size selected, the
powder may not dissolve fully.
Some powdered beverages
develop into ‘clumps’ when left
sitting for some time
Shake the powdered pods before
brewing to break up these clumps and
allow better clearing. For powdered
beverage with no filter, use the Cocoa
cycle selection
Brewer lid is difficult to close K-cup is not fully seated Press K-cup all the way down into the
brewer prior to closing the lid. Lower
needle must puncture K-cup bfore
closing the brewer lid
Brewer leaks during the brew cycle Trouble in closing brewer lid or
damaged K-cup
Press K-cup all the way down into the
brewer prior to closing the lid. Lower
needle must puncture K-cup bfore
closing the brewer lid. Recommend
using official Keurig K-cups that have
not been damaged and have a good
seal between the top cover and plastic
bottom
Troubleshooting Tips... Before you schedule service
TROUBLESHOOTING TIPS