User guide

GEL100340
3.1.6 Debugging prujects
To Debug
I
Simulate several cycles conthme
Stop the simulation
I
stop
Unload the model Unload DLL
Set probe on signal. Se& Probe
Create a monitor
Create a trace
Remove a probe
Remove all probes
create &$onitor
Create Trace
Remnve Probe
Remove &I
Probes
Shortcut Comments See paragraph
F5
F8
IReloads the model into memory and
initializes it.
9.5
~ The model is simulated once on the PC 9.5
FlO The model is simulated several times. 9.5
The number of cycles is determined by a
didOE.
AL,T+FS The model is unloaded and the data is 9.5
removed from the monitors
The model is removed from memory.
9.5
A probe is set on the selected signal 9.1
(connection line)
I
After selecting this menu item a signal is 9.1.1
selected which is monitored.
After selecting this menu item a signal is
9.1.1
selected to trace a signal.
Afier selecting this menu item a probe is 9.2
selected which will be removed.
All probes within the project are
removed.
9.2
Woo06
3.1.7 Tools
Generate a cross
3.1.8 Options
/oIyoRI r ::,,
Set the PC as the target
PC Simulation
Set the microcontroller
Target
C166asthetarget
I
Execution
I
system
I I
Set the settings of the
ISchgme
schematic -
Set general settings
Set the colors
Settings..
settings..
dolors..
Setting the external tools Xools
Code will be generated for the target 8.4
system
I
I
‘A dialog is opened for setting options of
10.1
the schemes
A dialog is opened for general settings. 10.2
A dialog is opened for setting the colors
10.3
within the schematics.
A dialog is opened that where external 10.4
tools that extend the tools menu are
defined