User guide

GEL100340

4.4.3 Block

Selection Bar

The block selection bar provides quick access to the building blocks of the schematics. It is divided into two

parts: the left part is used for selecting a group. The members of the selected group are displayed on the right

half of the bar. Placing of a block is done by dragging and dropping a block into the schematic.

The block selection bar can be made hidden or visible by the menu item Block Toolbar of the View menu.

CtB

fTJ

Zag

GasB&y

c&j

emwmf!

Figure 4.4.3.1: Block Selection Bar

4.4.4 Status Bar

5z$iMse

‘&

i$e#atlFnr

Figure 4.4.4.1: Status Bar

lg,,d-

The status bar is located at the bottom of the main window and gives information about the schematic being

edited On the left side the following items are displayed:

if the mouse pointer is on a button of the toolbar an explanation of the button is given

if the mouse pointer is on a button of the block selection bar, its name is displayed

if the mouse is within the schematic during editing the name of the block it is pointing to is displayed

in all other cases this part is left empty

The right part of the status bar displays information about the status of the project:

saved ufrer

saving to disk,

changed

after editing changes,

run

if simulation is active.