User guide

Wintllrive

5.8 Printing Schematics

For documentation purposes Win+Drive schematics can be printed. Printing is started

by the Print command

from the

File

menu. A dialog appears that is used for setting the print options. There are two modes for

printing schematics:

window print mode

page print mode

The window print mode is used for draft printouts, while the page print mode delivers document ready prints.

Both modes are started from the Print item of the File menu.

Figure 5.8.1: Window Print Mode Dialog

5.8.1

Printing in Window Mode

For printing a scheme in window mode select

from the

File

menu and then

Window mode

from the tab

riders of the dialog. The window mode dialog appears.

Within this dialog you can change the following options:

the margins of the printing at all four borders in inches. These margins will not be printed. They should be

bigger than the printer margins.

the print range can be selected between the visible window and the whole schematic.

the printing especially for larger schematics can be divided onto more than one page. For this purpose the

Multipage checkbox has to be marked.

If the Keep aspect ratio is checked, the magnification in x- and y-direction is the same. Otherwise they are

optimized to fit the schematic to the page.

If the Frame around page is checked, a border and a headline will be printed to identify the printout.

starts the printing while

Cancel

aborts it.

Setup

can be used to open the Page Setup dialog.