Owner's manual

Galaxy Pulsar Edge Power System Controller
Issue 3 October 2011 41
changing the mode of operation of the network port. This is achieved through the
reapplication of power. When this process is performed the controller accepts the new
Ethernet port configuration. The rebooting process takes approximately 2 minutes.
4
Attach the LAN cable between the controller’s LAN connection, RJ45 (J5), located at
the rear of the shelf to the appropriate Ethernet port on the Craft PC.
5
Open the PC’s browser and enter the controller’s WIP (Working IP address) as the
destination address. This address should be
http://192.168.2.1. The Pulsar Edge has
HTTP capabilities and should begin to return appropriate system representative web
pages.
4
Using a standard browser, a login page similar to that depicted below should be served
up by the Pulsar Edge controller.
There are three levels of access through the port; Read-
Only, Read/Write, and
Read/Write with password management privileges. Passwords defaults for the Craft port
as well as other remote access means default as follows:
Access Default Password
User (Read-Only) lineage
Super-User (Read/Write) super-user
Administrator (Read/Write/Password Administration) administrator
Once the password is entered a screen simil
ar to the following, similar to that with EV2,
should appear.
Security Levels/Passwords
The Pulsar Edge supports three levels of access: (User, Super-User, and Administrator). Password
defaults can be changed only by a user of administrator privileges.