User's Manual

LightGrid - Wireless Outdoor Lighting Control
(LightGrid 2 series)
FCC / IC Compliance Statements
Caution
Risk of injury. Wear safety glasses and gloves during installation and
servicing
Warning
Risk of electrical shock. Disconnect power before servicing or
installing product.
Risk of injury or damage. Unit if not installed properly. Follow
installation instructions.
Install in accordance with National Electric Code and local codes
FCC statements:
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
this equipment.
To satisfy FCC/ISED RF exposure requirements a separation distance
of 20 cm or more must be maintained between the antenna of this
device and persons during operation.
Operation at closer than 20cm is not permitted.
CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada license-exempt RSS
standards.
Operation is subject to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including
interference that may cause undesired operation.
Cet appareil est conforme aux normes RSS exemptees de licence de
Industrie Canada.
Son fonctionnement est soumis aux deux conditions suivantes:
• Cet appareil ne doit pas provoquer d'interférences et
• Cet appareil doit accepter toute interférence, y compris celles
pouvant causer un mauvais fonctionnement de l'appareil.
Pour être conforme aux limites d’exposition aux ondes RF des
normes FCC/ISED, une distance de séparation d’au moins 20 cm doit
être maintenue entre l’antenne de cet appareil et toute personne
pendant son opération. Mettre en opération cet appareil a une
distance plus rapprochée que 20 cm n’est pas permis.