User's Manual

05-3946A01, Rev. C TransNET OEM Integration Guide I-1
INDEX
A
Accessories (table) 6
ADDR command (set/display radio
network address) 41
Alarm
checking for 58
code definitions 59
codes 58
codes, table 59
major vs. minor 59
receiver timeout (RXTOT
command) 52
reset output signal 42
set/display output sense (ASENSE
command) 42
status (STAT command) 55
ALARM command (superseded; see
STAT command) 55
Alarm Mask (AMASK) Command 42
Alarm Sense (ASENSE) Command 42
Alarm Status Command (STAT) 55
AMASK command (configure alarm
output signal) 42
Antenna
performance optimization 15
selection 13
SWR check 16
system gain vs. power output setting,
table 18
Yagi, illustrated 14
ASENSE command (set/display alarm
output sense) 42
B
BAUD command (set/display data
interface port attributes) 42
Baud rate
setting 17
setting for RJ-11 DIAG port (DLINK
command) 62
Benchtop Setup & Evaluation 7–11
BUFF command (set/display received
data handling mode) 43
C
Cable
data equipment to DATA
INTERFACE connector 34
data interface wiring for tail-end
links 10, 20
feedlines 14
Clear Zone Statisics Log, ZONE
CLEAR 57
Clear-to-Send Delay (CTS)
Command 44
Clear-to-Send Hold Time (CTSHOLD)
Command 44
Clock-Synchronizing Master Address
(CSADDR) Command 44
CODE command (display/set
encryption value) 43
Command 48
TEMP (radio’s internal temperature
reading) 56
Commands
ADDR (set/display radio network
address) 41
AMASK (configure alarm output
signal) 42
ASENSE (set/display alarm output
sense) 42
BAUD (set/display data interface
port attributes) 42
BUFF (set/display received data
handling mode) 43
CODE (set/display encryption
value), See also Encryption 43
CTS (set/display CTS line response
timer) 44
CTSHOLD (set/display CTS hold
timer) 44
detailed descriptions 41–57
DEVICE (set/display DCE or CTS
Key behavior) 45
display operating status 37
DKEY Command, Turn off radio
transmitter test signal 45
DTYPE (set radio’s diagnostics
type) 46
FEC (Forward Error Correction) 46
FEC (Forward Error Correction)
Command 46
HOPTIME (set/display hoptime
setting) 46
how used 41
INIT (restore factory default
settings) 46