User's Manual

I-4 TransNET OEM Integration Guide 05-3946A01, Rev. C
performance optimization 15
tail-end links 9, 20
Interference
about 33
checks 17
troubleshooting 61
interference 33
K
Key
set to CTS keying (DEVICE
command) 45
transmitter, for antenna SWR
check 16
KEY command (key transmitter) 16,
53
L
LED status indicators
table 11, 60
Low-Power Mode (LPM)
Command 48
Low-Power Mode Sleep Time
(LPMHOLD) Command 49
LPM Command (low-power mode) 48
LPMHOLD Command 49
M
Map 56
Map of Extension Addressses
(XMAP) 56
Master Station
default settings 47
MIRRORED BITS™ Protocol
Support 30, 31
MODE Command 49
MODE command (display/set radio
mode as master, remote, or
extension) 49
MODE command (display/set radio’s
operating mode as master, remote, or
extension) 49
Model configuration code,
illustrated 72, 80
Modes
Low-Power Mode versus Remote’s
Sleep 30
Mounting
instructions/dimensions 11–12
Multiple Address System (MAS)
network, illustrated 4
N
Network Address (ADDR)
Command 41
Network configuration commands 36
Network Diangnsotics Mode (DTYPE)
Command 46
Network-wide diagnostics
procedures 62
Node (radio diagnostics type) 46
O
LED 48
Modbus, BUFF 43
OWM command (set/display optional
owner’s message) 50
OWN command (set/display optional
owner’s name) 50
Owner’s Message (OWM)
Command 50
Owner’s Name Command (OWN) 50
P
PC
connecting to radio’s diagnostic
port 62
launching InSite application at 62
performing diagnostics using
connected 62
Peer (radio diagnostics type) 46
Performance optimization 15
Pins, DATA INTERFACE connector
descriptions (table) 79
Point-to-point system
link, illustrated 5
PORT command (set/display current
data port) 50
Power
Low-Power Mode versus Remote’s
Sleep 30
Power (RF)
how much can be used 15
Measurement 54
set/display RF forward output (PWR
command) 50
Power saving mode (see Sleep Mode)
Primary Extension Address (XPRI) 57
Procedures
antenna aiming 16