User's Manual

10 TransNET OEM Integration Guide 05-3946A01, Rev. C
Any device on the left that requires a keyline, as in this illustration, will
require the bottom line (CTS to RTS) and the TransNET OEM on the right
will need its
DEVICE type set to CTS KEY. See DEVICE, on Page 44 for
details.
3.3 Configuring a Network for Extensions
The installation and configuration of an Extension transceiver is straightfor-
ward with only a few unique parameters that need to be considered and set at
each unit.
In every network there can be only one Master station. It will serve as the sole
gateway to the outside world. The tables in “Configuration Parameters for
Store & Forward Services” on Page 24 detail the parameters that need to be
set on each type of radio in the network. For a detailed description of this
network design, see “SAF Operation with Extension Radios” on Page 20.
3.4 LED Indicators
The LED indicators are located to the right of the transceiver’s shield cover
(near J3) and show important information about status of the module. The
functions of LEDs are explained in Table 4 below.
NOTE: For the LEDs to function, they must be enabled using the LEDS ON command.
Within 16 seconds of power-up, the following indications will be seen if the
unit has been properly configured and is communicating with another trans-
ceiver:
•
GP (General Purpose) lamp lit continuously
•
DCD lamp lit continuously (if unit is synchronized with another station)