User's Manual

52 TransNET OEM Integration Guide 05-3946A01, Rev. C
• Synthesizer frequencies are reset to the test frequencies specified by the
TX and RX commands described earlier.
• The radio can be keyed using the
KEY command. DKEY is used to unkey
the radio. (If the radio is left in a keyed state it is automatically unkeyed
after 10 minutes.)
• The
RSSI is sampled in a raw, continuous fashion regardless of whether
the unit is a Master or a Remote.
Entering
Q or QUIT returns the system to normal operation.
A timer keeps the Setup mode from accidentally leaving the system disabled.
After 10 minutes the system behaves as if
Q or QUIT had been entered,
returning the unit to normal operation.
NOTE: TransNET uses a automatic level control in normal operation to keep transmit power
constant over time. This facility is disabled in Setup mode. To test 1 Watt power output
in Setup mode, the user must enter PWR 30 followed by
KEY. The power output will
only be valid for the first couple of seconds.
SER
Radio Serial Number
Displays the serial number of the radio.
SHOW CON
Show Virtual Connection Status
Shows virtual connection status established by the latest ATDT command
sequence. (Works only with AT ON. See“AT [ON, OFF]” on Page 41)
If no connection is established, it displays
NONE.
If a connection is active, it will display:
<Master unit address> TO <Remote (“dialed”) unit address>.
SHOW PWR
Show Measured RF Transmit Power
The SHOW PWR command displays the actual (measured) RF power output
in dBm. Unlike the PWR command, this command shows the actual level
being measured, not the programmed RF power setting.
SHOW SYNC
Show Clock-Synchronization Master Network Address
When used at a Remote station, this command will display Extended Address
and
Unit Address of the Master or Extension radio to which the Remote is
synchronized. The network depth at the Remote, defined as the number of
downstream links from the Master, is displayed in parentheses.
SHOW SYNC works for Dependent Masters. A value of zero (0) means the
station is a Master synchronized to a Clock-Sync Master. The
SHOW SYNC
command will display an asterisk (*) after depth value if the radio is operating
with co-located Masters.