User's Manual

05-3946A01, Rev. C TransNET OEM Integration Guide 69
4INRS-232Diagnostic RXD—Accepts diagnostic/administrative
data from the connected device.
5IN —DC Input (6–30 Vdc)— Supply Source must be capa-
ble of furnishing at least 7.5 watts.
6INTTL, 3 VdcSleep Mode Input—A ground on this pin turns off
most circuits in a remote radio. This allows for greatly
reduced power consumption, yet preserves the radio’s
ability to be brought quickly back on line. See “Using
the Radio’s Sleep Mode (Remote Units Only)” on
Page 26 for details.
7 OUT TTL, 3 Vdc Data Carrier Detect (DCD)—A low indicates hop-
ping synchronization has been achieved.
8INTTL, 3 VdcPower Supply Shutdown Control—A ground on this
pin causes the OEM module’s power supply to shut
down.
9 — — Reserved—Do not connect.
10 IN RS-232,
± 5 Vdc
Transmitted Data (TXD)—Accepts payload data
from the connected device.
11 IN — DC Input 6–30 Vdc)— Supply Source must be capa-
ble of furnishing at least 7.5 watts.
12 IN RS-232,
± 5 Vdc
Request to Send (RTS)—A high causes CTS to fol-
low after the programmed CTS delay time has elapsed
(DCE).
13 — — Reserved—Do not connect.
14 OUT RS-232,
± 5 Vdc
Received Data (RXD)—Supplies received payload
data to the connected device.
15 IN — Ground—Connects to ground (negative supply poten-
tial).
16 OUT RS-232,
± 5 Vdc
Clear to Send (CTS)—Goes high after the pro-
grammed CTS delay time has elapsed (DCE), or keys
an attached radio when RF data arrives (CTS KEY).
Table 29. Transceiver Connector J3 Pinouts
Payload data RS-232; Diagnostic data RS-232 (Continued)