User's Manual

74 TransNET OEM Integration Guide 05-3946A01, Rev. C

Figure 18. OEM Evaluation Board (P/N 03-4051A01)

For detailed information on the transceiver module’s Interface connector, J3,

review the series of tables beginning on Page 66.

Connecting the Transceiver & Evaluation Board

To connect the Evaluation Board to the radio as shown in Figure 19, carefully

align the pins of the 16-pin header with J3 on the transceiver module and

press down firmly. The radio PC board should seat solidly on the four

standoff spacers. Use nuts to secure the board to the standoffs.

Invisible place holder

Figure 19. Connecting the Transceiver (upper PCB)

and Evaluation Board (lower PCB) Together

CAUTION: Take care to avoid short-circuiting the underside of the Evaluation PC board. The

bottom of the board is not insulated, and contact with metallic objects on the work sur-

face could cause damage to the board or connected equipment.

TEST PROBE

POINTS

DIAGNOSTIC

COMMUNICATIONS

(RJ-11)

DATA CONNECTOR

(DB-9)

DC POWER

(5–25 VDC)

STANDOFF SPACERS (4) TRANSCEIVER INTERFACE

(16-PIN HEADER)

JUMPER BLOCK