User's Manual

TRAIN CHIEF® II LRCS w/Lightweight OCU OWNER’S MANUAL
95-00-0-xxx Rev 000 3-4 Control Chief Corporation
OCU Operation Controls and Associated Functions
Figure 3-3: Lightweight OCU-BTIND Controls
Power Button:
Push-On / Push-Off switch to apply power to the OCU. Power is supplied from the battery pack
and the power bridge. Depending on the charge state of the power bridge, the OCU may
activate for a short time without an installed battery. See page 6-2.
Pitch button:
The PITCH button is used to transfer movement control of the locomotive from one OCU to
another. Refer to page 4-2 in this manual describing the Selective Dual Control feature.
Tilt Time Extend (F1):
The Tilt Time Extend button extends the allowable tilt time to 60 seconds. To activate this
command the operator must depress the F1 button for 2 seconds until the OCU beeps to
acknowledge the command.
Status (F4):
Depressing the F4 key causes the OCU to initiate a status report from the locomotive or activate
a status menu that will be shown on the OCU display. Refer to the OCU display section on
page 6-8 for more details.
IR Port:
The IR port is used when registering the OCU to the locomotive. Aligning the IR ports of the
OCU and RCU during setup allows specific information to be exchanged between them. This
creates a secure communications link between them for the duration of the remote control
session. See Chapter 4 for complete registration procedures.
Pitch
Power
Tilt Time Extend (F1) Status (F4)
IR Port