User's Manual

TRAIN CHIEF® II LRCS w/Lightweight OCU OWNER’S MANUAL
95-00-0-xxx Rev 000 4-3 Control Chief Corporation
¾ Turn on the Lightweight OCU by pressing the Power-On pushbutton at the lower right
hand corner of the unit (see Figure 3-3). At power-on the OCU will perform a Power-On-
Self-Test (POST). When POST has completed successfully the unit is ready to be
assigned to a Train Chief® II equipped locomotive.
A successful POST is indicated by the flashing OCU indicators and display message (“OCU >
LOCO ALIGN IR”).
If an error is detected during the POST an error message will be displayed and the unit will be
disabled. See the troubleshooting section for further details.
OCU Assignment Procedure – Register OCU with Locomotive
How to Register the OCU for single man operation.
At Receiver Power up: IR Indicating LED illuminated (RED)
¾ Power up Transmitter and wait for POST. Follow prompts on Transmitter display.
¾ Align Transmitter IR port with Receiver IR Window on Enclosure front (Fig 6.1).
¾ Once the IR Process is complete the Transmitter will BEEP. Press the “RESET”
button to initiated RF communication. The IR Indication LED will go off.
At Transmitter Only Power up (Receiver already ON) LED Not illuminated:
¾ Power up Transmitter and wait for POST. Follow prompts on Transmitter display.
¾ Push & hold (for 3 seconds till LED comes on) the IR REQUEST pushbutton.
¾ Align Transmitter IR port with Receiver IR Window on Enclosure front (Fig 6.1)
¾ Once the IR Process is complete a Transmitter will BEEP. Pre4ss the “RESET”
button to initiated RF communication. The IR Indication LED will go off.
OCU Configuration Incompatibility Messages and Definitions:
Display Message Definition Action
CONFIG
Model/Owner is not compatible.
OCU Models can not be
interchanged with RCUs or with
different equipment owners.
Obtain the unit(s) configured for the RCU and
register. Refer to the configuration label next
to the IR Port on the RCU. (For MU&Go
RCUs this label is inside the enclosure door.)
RADIO
OCU and RCU Radio model types
incompatible
Obtain the unit(s) configured for the RCU and
register. Refer to the configuration label next
to the IR Port on the RCU. (For MU&Go
RCUs this label is inside the enclosure door.)
BAND Radio out of Band
Obtain the unit(s) configured for the RCU and
register. Refer to the configuration label next
to the IR Port on the RCU. (For MU&Go
RCUs this label is inside the enclosure door.)