User's Manual

TRAIN CHIEF® II LRCS w/Lightweight OCU OWNER’S MANUAL
95-00-0-xxx Rev 000 4-10 Control Chief Corporation
Transferring from Remote to Manual
¾ Go to the locomotive and place the independent brake handle into the FULL APPLY
position and the automatic brake handle to the EMERGENCY position.
¾ Place the transfer switch on the receiver / controller unit in the MANUAL position.
¾ Place the air valve that feeds the receiver / controller unit in the OFF/MANUAL position.
¾ Place the brake pipe isolation valve in the MANUAL position.
¾ Recover from the locomotive PCS fault condition using the normal procedure.
¾
Move the auto automatic brake handle to the RELEASE position.
¾
If Trainline Braking option is installed:
o For systems utilizing the J1 relay valve for trainline, place the trainline isolation
valve to the MANUAL position.
o For systems utilizing the 26L brake cover for trainline, place the trainline dump
valve to the CLOSED or MANUAL position.
¾
Move the independent brake handle to the SET position.
¾ Turn off and secure the OCU to provide protection against unauthorized operation.
¾ Resume normal operations.