User's Manual

TRAIN CHIEF® II LRCS w/Lightweight OCU OWNER’S MANUAL
95-00-0-xxx Rev 000 6-2 Control Chief Corporation
¾ Anytime the locomotive is returned to manual operation or the OCU power is switched
OFF, the stored data will be lost requiring the assignment process to be repeated. The
OCU will not lose its assignment data during a “hot battery swap” if the swap is
accomplished promptly, within approximately 1 minute.
IR Registration Process:
At Receiver Power up: IR Indicating LED illuminated (RED)
¾ Power up Transmitter and wait for POST. Follow prompts on Transmitter display.
¾ Align Transmitter IR port with Receiver IR Window on Enclosure front (Fig 6.1).
¾ Once the IR Process is complete the Transmitter will BEEP. Press the “RESET”
button to initiated RF communication. The IR Indication LED will go off.
At Transmitter Only Power up (Receiver already ON) LED Not illuminated:
¾ Power up Transmitter and wait for POST. Follow prompts on Transmitter display.
¾ Push & hold (for 3 seconds till LED comes on) the IR REQUEST pushbutton.
¾ Align Transmitter IR port with Receiver IR Window on Enclosure front (Fig 6.1)
¾ Once the IR Process is complete a Transmitter will BEEP. Pre4ss the “RESET”
button to initiated RF communication. The IR Indication LED will go off.
OCU Controls
Figure 6-2: OCU-BTIND Main Controls
1. Throttle Selector:
Ten detents for HALT, IDLE and eight (8) increments of throttle position. The throttle selection
is indicated by LEDs on the display.
Throttle select positions:
• Halt: commands the throttle to idle, removes generator field and applies
independent brakes in a controlled manner.
1
2
3
4
5
6
7
8
9
10
12
11
13
14
15