User Manual

44 MDS entraNET 900 System Guide (Preliminary) MDS 05-4055A01, Rev. A
2.6.1 Approved Remotes/Access Points List Menu
This menu is the same for both Access Points and Remotes and the
names change to reflect their mode. Replace “Remotes” with Access
Points” in the following description.
Figure 2-21. Approved Remotes List Menu
• Add Remote—Enter MAC address of Remote.
[Any valid 6-octet MAC address; 00:00:00:00:00:00]
• Delete Remote—Enter MAC address of Remote.
For security purposes, you may want to delete a stolen or depro-
visioned radio.
• Add Associated Remotes—Add all currently associated
remotes (1-255) to the approved remote list. Alternatively, you
can enter each Remote MAC manually.
• Delete All Remotes—Remove (complete purge) of all
Remotes from current list.
• View Approved Remotes—Simple listing of approved
Remotes by MAC address, of radios authorized to join this AP.
If a Remote is not in this list, it will not be able to associate with
this AP.
• Save Changes—Save all changes made during this session
with this menu. Changes will be implemented only if they are
“saved” before exiting this menu.
2.7 PERFORMANCE VERIFICATION
After the basic operation of the radio has been checked, you may wish
to optimize the network’s performance using some of the following sug-
gestions. The effectiveness of these techniques will vary with the design
of your system and the format of the data being sent.
There are two major areas for possible improvement—the radio and the
data network. The following sections will provide you with a variety of
MIS Wireless IP Host
Approved Remotes List Menu
-==========================================================================-
A) Add Remote 00:06:3D:00:0B:D7 Remote Added
B) Delete Remote 00:00:00:00:00:00
C) Add Associated Remotes
D) Delete All Remotes
E) View Approved Remotes
F) Save Changes
Select a letter to configure an item, <ESC> for the prev menu