User's Manual

05-6301A01, Rev. 01 MDS Mercury Series Quick Start 1
MDS Mercury Series
Setup Guide
MDS Mercury
TM
Series transceivers provide an easy-to-install
wireless network service with long range and secure operation at
adaptive data rates approaching 30 Mbps. The transceiver is
designed for demanding applications in industrial environments,
where reliability and range are paramount.
The transceiver comes in two primary models—Base Station (BS)
and Subscriber Unit (SU), each with unique hardware profiles.
Both models support Ethernet and serial services.
A BS is a wireless switch that usually provides connectivity into a
wired Ethernet LAN/WAN. Subscriber Units associate over the air
with a BS and are typically connected to an Ethernet or Serial
device via a local cable.
NOTE: To determine whether a unit is an BS or Subscriber Unit,
check the dome label on the top of the unit.
Refer to the Mercury Series Technical Manual (05-6302A01) for
advanced procedures and cautionary information.
1.1 Connectors & Indicators
Figure 1 shows the connectors and indicators of a Standard BS.
These items are referenced in the installation and operation steps
that follow. Note that SU radios may have an additional connector
present for WiFi service, depending on order requirements. If WiFi
is not provided on an SU, the GPS connector will also be absent.
Invisible place holder
Figure 1. Connectors and Indicators
(Standard BS shown; SU Similar)
There are three main requirements for installing the transceiver—
adequate and stable primary power, a good antenna system, and
the correct interface between the transceiver and the data device.
Figure 2 shows a typical Mercury installation.
2.1 Installation Steps
Listed below are the basic steps for installation. It is highly recom-
mended that the BS be installed first so that you can quickly check
the operation of each associated SU as it is placed on the air.
Invisible place holder
Figure 2. Typical Mercury Installation (SU Shown; BS Similar)
2.1.1 Step 1—Mount the Transceiver
Use the supplied 6-32 x 1/4 inch (6 mm) screws to attach the
mounting brackets to the bottom of the radio. Figure 3 shows the
mounting dimensions of the unit. Mount the radio to a stable sur-
face. (Fasteners not supplied.)
Invisible place holder
Figure 3. Transceiver Mounting Dimensions
(Dimensions for BS and SU identical)
2.1.2 Step 2—Install the Antenna
Base units typically use sector antennas, while SU’s typically use
a directional panel antenna. All antennas should be mounted in the
clear to a sturdy support. Connect the antenna’s feedline cable to
the transceiver’s WiMAX Antenna Port. To minimize RF interfer-
ence, the antenna should be at least 9 inches (> 23 cm) away from
connected device(s), sensors and other external components.
1.0 INTRODUCTION
2.0 INSTALLATION
DC INPUT
(1060 VDC, 4A MAX)
RS-232
SERIAL PORT
LAN PORTS
USB PORTS
(Mini-A, Type-A)
GPS ANTENNA
CONNECTION
WiMAX RF
CHANNEL 1
WiMAX RF
CHANNEL 2
LED INDICATOR
PANEL
TO DC POWER SUPPLY
(1060 Vdc)
RTU/PLC
LOW-LOSS FEEDLINE
(To Station Antenna)
PC RUNNING
TERMINAL
PROGRAM
(Straight-Through
Cable to Radio)
TO GPS ANTENNA
(Provides 3.3 Vdc output)
Crossover Cable
to Radio
ANTENNA SYSTEM
Subscriber: Panel Ant.
Base Unit: Sector Ant.
2.75˝ (7 cm)
8 5/8˝ (21.8 cm)