User's Manual

52 MDS Mercury 16E Technical Manual MDS 05-6302A01, Rev. A
Configuration – IP
& Networking
VLAN Status The VLAN Status parameter controls
whether the VLAN capability of the
device is enabled or not. Enabling the
VLAN Status allows the configuration
of trunk and access ports along with
VLAN IDs and VLAN IP Addresses.
Disabled
IP Address Mode The Mercury transceiver can be
configured with a static IP address or it
can used DHCP to obtain an IP
address from a server on the network.
Static
Static or Dynamic
Static IP Address This is the IP address that the Mercury
transceiver uses for its management
interfaces (web, SNMP, SSH, and
telnet).
192.168.1.1
Static IP Netmask This is the Netmask used in
conjunction with the Static IP Address
255.255.255.0
Static IP Gateway This is the IP address of a Gateway
device on the network used for
inter-subnet routing.
0.0.0.0
Configuration -
Radio
Frequency This is the operating frequency of the
WiMAX radio interface. Frequency
range limits can be affected by
bandwidth selection.
3662.5 or 1815 MHz
3651.75 to 3670
1800 to 1830
RF Bandwidth This is the operating bandwidth of the
WiMAX radio interface.
3.5 MHz
3.5, 5, 7, 8.75, 10
Adaptive Modulation This parameter allows the WiMAX
modem to automatically choose the
modulation and FEC coding rate that
best matches the channel.
Enabled
Adaptive Modulation
Estimation Margin
3dB
0 to 100
Protection Margin 3
0 to 10
Hysteresis Margin 3
0 to 10
MIMO Type The MIMO Type parameter controls
the use of the second RF antenna port.
In Matrix A/B mode, the Mercury
transceiver automatically chooses the
appropriate operating mode according
to the packet error rate (PER)
performance of the wireless channel.
None
None, Matrix A, Matrix
A/B
Table 7. Configuration Parameters
Location Parameter Description Default Value
Possible Values