User's Manual

72 Mercury Reference Manual 05-4446A01, Rev. C
¥ ModeUDP Point-to-Point. This is the type of IP port
offered by the transceivers serial device server.
[
TCP, UDP; TCP]
¥ RX IP PortPort number where data is received and passed
through to the serial port. The application connecting to this
transceiver must use this port number.
[
1—64,000; 30010]
¥ TX IP AddressData received through the serial port is sent to
this IP address. To reach multiple Remotes in the network,
use UDP Point-to-Multipoint.
[
Any legal IP address; 0.0.0.0]
¥ TX IP PortThe destination IP port for data packets received
through the serial port on the transceiver.
[
1—64,000; 30010]
¥ Talkback EnableTalkback is a mode where the radio returns
a serial message received within a time-out period back to the
last address of an incoming UDP message. If the time-out
expires, the unit sends the serial data to the configured
address. [
Enable, Disable; Disabled]
¥ Baud RateData rate (payload) for the COM port, in
bits-per-second. [
1,200—115,200; 19200]
¥ Byte FormatFormatting of data bytes. Data bits, parity and
stop bits. [
7N1, 7E1, 7O1, 8N1, 8E1, 8O1, 8N1, 7N2, 7E2, 7O2, 8N2,
8E2, 8O2; 8N1
]
¥ Buffer SizeMaximum amount of characters that the Remote
end buffers locally before transmitting data through the serial
port. [
1—255; 255]
¥ Inter-Packet DelayAmount of time that signal the end of a
message, measured in tenths of a second. [
default = 1 (that is,
1/10th of a second)
]
¥ Commit Changes and Exit WizardSave and execute changes
made on this screen (shown only after changes have been
entered).