User's Manual

05-4446A01, Rev. C Mercury Reference Manual 73
Configuring for TCP
Mode
Invisible place holder
Figure 3-36. TCP Client Menu (Remote)
¥ StatusEnable/Disable the serial data port.
¥ ModeTCP Client. This is the type of IP port offered by the
transceivers serial device server. [
TCP, UDP; TCP]
¥ TX IP AddressThe IP address to be used as a destination for
data received through the serial port.
[
Any legal IP address; 0.0.0.0]
¥ TX IP PortThe destination IP port for data packets received
through the serial port on the transceiver.
[
Any valid IP port; 30010]
¥ TCP KeepaliveAmount of time (in seconds) that the trans-
ceiver waits for data before terminating the TCP session.
[
0—600; 600]
¥ Baud RateData rate (payload) for the COM port, in
bits-per-second. [
1,200—115,200; 19200]
¥ Byte FormatInterface signaling parameters. Data bits, parity
and stop bits.
[
7N1, 7E1, 7O1, 8N1, 8E1, 8O1, 8N1, 7N2, 7E2, 7O2, 8N2, 8E2, 8O2;
8N1
]
¥ Buffer SizeMaximum amount of characters that the Remote
end buffers locally before transmitting data through the serial
port. [
1—255; 255]
¥ Inter-Frame Packet DelayA measurement representing the
end of a message, measured in tenths of a second.
[
default = 1 (that is, 1/10th of a second)]
¥ Commit Changes and Exit WizardSave and execute changes
made on this screen (shown only after changes have been
entered).