User's Manual

98 Mercury Reference Manual 05-4446A01, Rev. C
¥ Maximum Receive ErrorsSelect this item to change the maxi-
mum allowable number of receive errors. When the number of
errors exceeds this number, a redundancy switchover occurs.
[
0-1000; 500]
3.9 GPS CONFIGURATION (REMOTE
ONLY)
This menu allows you to view or set important parameters for the
built-in Global Positioning System (GPS) receiver in the Mercury
Remote.
Invisible place holder
Figure 3-67. GPS Configuration Menu (Remote Only)
¥ Stream GPS to ConsoleUsed to enable/disable streaming of
GPS NMEA data to the console port (
COM1). Baud rate is 4800
baud when Stream GPS to console is enabled.
[
enabled, disabled; disabled]
¥ GPS to Console Baud RateThe serial baud rate when GPS
streaming is enabled.
¥
Send GPS via UDPUsed to enable/disable sending GPS NMEA
data to a server via UDP. [
enabled, disabled; disabled]
¥ GPS UDP Server IP AddressSpecify the destination address for
GPS NMEA UDP packets. [
any valid IP address; 0.0.0.0]
¥ GPS UDP Server UDP PortDestination UDP port for GPS
NMEA UDP packets. [
valid UDP port number; 0]
¥ GPS Streaming ConfigurationA submenu for setting GPS
NMEA outputs. (See
Figure 3-68 on Page 99.)