User's Manual

44 Mercury Reference Manual 05-4446A01, Rev. C
• AP Location Push Config—Presents a submenu for configuring an
AP to automatically force connected remotes to receive the AP
Locations file from the AP.
See “AP Location Push Config
Menu” on Page 55
for details.
• SNTP Server—Address of SNTP server (RFC 2030) from which
the transceiver will automatically get the time-of-day. You can
also manually set the date and time. A Mercury unit tries to get
the time and date from the SNTP server only if an IP address is
configured. It will continue to retry every minute until it suc-
ceeds.
The transceivers use UTC (Universal Time Coordinated) with a
configurable time offset. [0]
NOTE: The Mercury gets time of day data from the GPS receiver if the
receiver gets a satellite fix.
Network Interface Configuration Submenu
Invisible place holder
Figure 3-12. Network Interface Configuration Submenu
• VLAN Status—This selection is used to enable or disable virtual
LAN operation. For details, refer to
VLAN Configuration Menu
on Page 45
. [enable, disabled; disabled]
• IP Configuration—This selection presents a submenu for config-
uring the local IP address of the transceiver. Detailed explana-
tions are provided in the section titled
IP Configuration Menu
on Page 50
.
• DHCP Server Config—Menu for configuration of DHCP services
by the Access Point. DHCP provides “on-the-fly” IP address
assignments to other LAN devices, including Mercury Series
units. For details, refer to DHCP Server Configuration (Data
and Mgmt) on Page 48
.