User's Manual

05-4446A01, Rev. C Mercury Reference Manual 47
• Data VLAN Subnet Config—Presents a screen where you can view
or set the IP mode and address information (see
Figure 3-17 on
Page 49
).
• DHCP Server Config (Data)—Presents a screen where you can view
or set DHCP server status and address information for data
functions (see
Figure 3-16 on Page 49).
Management VLAN
Subnet
Configuration Menu
Invisible place holder
Figure 3-14. Management VLAN Subnet Configuration Menu
NOTE: Changes to any of the following parameters while communi-
cating over the network (LAN or over-the-air) might cause a
loss of communication with the unit you are configuring. You
must re-establish communication using the new IP address.
• IP Address Mode—Defines the source of the IP address of this
device. Only static IP addressing mode is available when VLAN
Status is enabled. [Static, Dynamic; Static]
• Static IP Address—The IPv4 local IP address. [192.168.1.1]
• Static IP Netmask—The IPv4 local subnet mask. This value is
used when the radio attempts to send a locally initiated message,
either from the terminal server, or from a management process.
[255.255.0.0]
The lower three lines of the screen (Current IP Address, Current IP Netmask,
Current IP Gateway) show the current addressing configured at the trans-
ceiver. Current IP Gateway only displays on this screen if Default Route IF
on the Network Interface Config menu (Figure 3-13 on Page 46) is set to
Management.
Selecting option I from the menu in
Figure 3-13 on Page 46 displays the
screen shown in
Figure 3-17 on Page 49. Note that the IP address is dif-
ferent even though it is the same physical unit. This is because this IP
address is defined for a different VLAN.