User's Manual

05-4446A01, Rev. C Mercury Reference Manual 73
• Commit Changes and Exit Wizard—Save and execute changes
made on this screen (shown only after changes have been
entered).
Configuring for TCP
Mode
Invisible place holder
Figure 3-36. TCP Client Menu (Remote)
• Status—Enable/Disable the serial data port.
• IP Protocol—TCP Client. This is the type of IP port offered by
the transceiver’s serial device server. [TCP, UDP; TCP]
• Primary Host Address—The IP address to be used as a destina-
tion for data received through the serial port.
[Any legal IP address; 0.0.0.0]
• Primary IP Port—The destination IP port for data packets
received through the serial port on the transceiver.
[Any valid IP port; 30010]
• Secondary Host Address—The IP address to be used as a desti-
nation for data received through the serial port, in case the
primary host address is not available.
[Any legal IP address; 0.0.0.0]
• Secondary IP Port—The destination IP port for data packets
received through the serial port on the transceiver, used along
with the secondary host address above.
[Any valid IP port; COM1: 30010]
• Outgoing Connection’s Inactivity Timeout—Amount of time (in
seconds) that the transceiver waits for data before terminat-
ing the TCP session. [0–600; 600]
• Data Baud Rate—Data rate (payload) for the COM port, in
bits-per-second. [1,200–115,200; 19200]
• Byte Format—Interface signaling parameters. Data bits, parity
and stop bits.
[7N1, 7E1, 7O1, 8N1, 8E1, 8O1, 8N1, 7N2, 7E2, 7O2, 8N2, 8E2, 8O2;
8N1
]