Reference Manual

128 Mercury Reference Manual 05-4446A01, Rev. E
• Retrieve File—Initiates the file transfer from the TFTP server.
The new file is placed into inactive firmware image. [Y, N ]
• Image Verify—Initiate the verification of the integrity of firm-
ware file held in unit.
• Image Copy—Initiate the copying of the active firmware into the
inactive image.
• Reboot Device—Initiates rebooting of the transceiver. This will
interrupt data traffic through this unit, and the network if per-
formed on an Access Point. Intended to be used for switching
between firmware images 1 and 2.
•
Advanced ReprogrammingAdvanced configuration options for
TFTP transfer of firmware files. See
Figure 3-107 and related
text descriptions.
•
Current Firmware—Displays the versions of firmware images
installed in the transceiver and shows whether Image 1 or Image
2 is currently active.
NOTE: See Upgrade Procedure on Page 130 for details on setting up
the TFTP server.
Invisible place holder
Figure 3-107. Advanced Reprogramming Menu
• TFTP Timeout—View/set the time (in seconds) where no activity
results in a TFTP timeout condition.
• TFTP Block Size—The data size of each TFTP block being trans-
ferred to the radio during firmware upgrade.
• Image Verify—Initiate the verification of the integrity of firm-
ware file held in unit.
• Image Copy—Initiate the copying of the active firmware into the
inactive image.
• Firmware Versions—Shows the available versions of firmware
code for operation of the radio.