Reference Manual

26 Mercury Reference Manual 05-4446A01, Rev. E
For benchtop evaluation, configure:
• Frequency Mode = Single Channel
• Single Frequency Channel = 0
• RF Bandwidth = 1.75
• TDD Sync = Free Run
For more information on configuring these parameters,
see “Frequency
Control Menu” on Page 67.
A unique IP address and subnet are required to access all IP-based man-
agement interfaces (telnet, SSH, SNMP, and Web), either through the
LAN port or remotely over-the-air.
2.6 STEP 5: CONNECT LAN OR
SERIAL DATA EQUIPMENT
Connect a local area network to the LAN port or a serial device to the
COM1 (DCE) port. The LAN port supports any Ethernet-compatible
equipment. This includes devices that use Internet Protocol (IP).
Figure 2-3 on Page 27 shows the interface connectors on the front panel
of the standard transceiver (Remote). The Option Set 1 Remote connec-
tors are shown in
Figure 2-4 on Page 28.
NOTE: The use of shielded Ethernet cable is recommended for
connection to the radio’s ETH port. The radio meets regulatory
emission standards without shielded cable, but shielding
reduces the possibility of interference in sensitive environ-
ments, and is in keeping with good engineering practice.
Table 2-1. Basic Configuration Defaults
Item Menu Location Default Values/Range
Network Name Main Menu>>
Radio Configuration>>
Network Name
MDS-Mercury • 1–15 alphanumeric
characters
• Case-sensitive;
can be mixed case
IP Address Main Menu>>
Network Configuration>>
IP Address
192.168.1.1 Contact your network
administrator
RF Output
Power
Main Menu>>
Radio Configuration>>
Transmit Power
+29 dBm (900 model)
+23 dBm (3650 model)
AP: -30 to +29 dBm
RM: 0 to +29 dBm
Unit Password Main Menu>>
Device Information>>
User Password
admin
(lower case)
• 1–13 alphanumeric
characters
• Case-sensitive;
can be mixed case