Reference Manual

80 Mercury Reference Manual 05-4446A01, Rev. E
• Commit Changes and Exit Wizard—Save and execute changes
made on this screen (shown only after changes have been
entered).
Invisible place holder
Figure 3-44. UDP Point-to-Point Menu
Configuring for UDP
Point-to-Point
Use UDP point-to-point configuration to send information to a single
device.
•
Status—Enable/Disable the serial data port.
• Mode—UDP Point-to-Point. This is the type of IP port
offered by the transceiver’s serial device server.
[
TCP, UDP; TCP]
• RX IP Port—Port number where data is received and passed
through to the serial port. The application connecting to this
transceiver must use this port number.
[
1—64,000; 30010]
• TX IP Address—Data received through the serial port is sent to
this IP address. To reach multiple Remotes in the network,
use UDP Point-to-Multipoint.
[
Any legal IP address; 0.0.0.0]
• TX IP Port—The destination IP port for data packets received
through the serial port on the transceiver.
[
1—64,000; 30010]
• Talkback Enable—Talkback is a mode where the radio returns
a serial message received within a time-out period back to the
last address of an incoming UDP message. If the time-out
expires, the unit sends the serial data to the configured
address. [
Enable, Disable; Disabled]
• Baud Rate—Data rate (payload) for the COM port, in
bits-per-second. [1,200—115,200; 19200]
• Byte Format—Formatting of data bytes. Data bits, parity and
stop bits. [7N1, 7E1, 7O1, 8N1, 8E1, 8O1, 8N1, 7N2, 7E2, 7O2, 8N2,
8E2, 8O2; 8N1]