User's Manual

7. Set the radio’s basic configuration with a PC terminal through the Host system. The three essential settings for
all transceivers are (See Section 3 for commands):
•Frequency
•Power
•Modem
8. In a normally operating system, you will see the CR100 POWER LED turn on at start-up.
9. Optimize the installation by checking:
•Antenna aiming and SWR check
•Optimal baud rate setting
•Radio interference checks
3.0 RADIO PROGRAMMING
There are no manual adjustments on the radio. All programming and control is performed through a PC connected to
the Host platform that interfaces with the radio’s J200 MiniPCIe card edge connector.
3.1 User Commands
The following tables provide descriptions of the various user commands for the transceiver.
Table 2. NX915 User Commands