User Manual

MDS 05-4670A01, Rev. E SD Series Reference Manual (x710 Mode) 21
3. Press the key several times at half-second intervals to
choose and select the correct baud rate. This will result in the >
prompt.
Invisible place holder
Figure 17. PC Connection to Transceiver
NOTE: TX and RX frequencies might not be set when the radio is
shipped from the factory, depending on ordering options. If
frequencies have not been set, the PWR LED will flash, indi-
cating an alarm condition. The alarm will clear after the
frequencies are set. In all cases, users should verify that the
frequencies are properly set in accordance with the station
license.
6.0 TRANSCEIVER MANAGEMENT
To perform transceiver management, connect a PC as described in
Section 5.1, Initial Startup & Checkout and obtain the > prompt.
6.1 Software Commands
Table 11 is a reference chart of software commands for the transceiver.
Programmable information is shown in brackets [ ] following the com-
mand name. See Section 6.2, Detailed Command Descriptions (Page
21) for detailed command descriptions.
Entering Commands
To enter a command, type the command, followed by . For pro-
gramming commands, the command is followed by and the
appropriate information or values, then .
Table 11. Command Summary
Command name Function
AK Details Page 25 The Authorization Key and a list of authorized
features.
ALARM Details Page 25 Read current operating condition of radio.
AMASK [0000 0000–FFFF
FFFF] Details Page 25
Set/display hex code identifying which events
trigger an alarm.
ENTER
PC Running Terminal Session
Transceiver
DB-9M to COM1 Port
ENTER
SPACE
ENTER