User Manual

Table Of Contents

vi SD Series Reference Manual (x710 Mode) MDS 05-4670A01, Rev. E

CSA Conditions of Approval: The transceiver is not acceptable as a stand-alone unit for use in the

hazardous locations described above. It must either be mounted within another piece of equipment

which is certified for hazardous locations, or installed within guidelines, or conditions of approval,

as set forth by the approving agencies. These conditions of approval are as follows: The transceiver

must be mounted within a separate enclosure which is suitable for the intended application.The

antenna feedline, DC power cable and interface cable must be routed through conduit in accor-

dance with the National Electrical Code. Installation, operation and maintenance of the transceiver

should be in accordance with the transceiver's installation manual, and the National Electrical

Code. Tampering or replacement with non-factory components may adversely affect the safe use

of the transceiver in hazardous locations, and may void the approval. A power connector with

screw-type retaining screws as supplied by GE MDS must be used.

Do not disconnect equipment unless power has been switched off or the area is known to

be non-hazardous. Refer to Articles 500 through 502 of the National Electrical Code

(NFPA 70) for further information on hazardous locations and approved Division 2 wiring

methods.

BSD License Information

The SD Series products contain source code originally released as part of “WPA Supplicant” which

is copyrighted as indicated below and is redistributed under the terms of the BSD license:

WPA Supplicant

BSD License

-------

Redistribution and use in source and binary forms, with or without modification, are permitted pro-

vided that the following conditions are met:

1. Redistributions of source code must retain the above copyright notice, this list of conditions and

the following disclaimer.

2. Redistributions in binary form must reproduce the above copyright notice, this list of conditions

and the following disclaimer in the documentation and/or other materials provided with the distri-

bution.

3. Neither the name(s) of the above-listed copyright holder(s) nor the names of its contributors may

be used to endorse or promote products derived from this software without specific prior written

permission.

THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS

“AS IS” AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIM-

ITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A

PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT

OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,

SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT

LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,

EXPLOSION

HAZARD!