Users Manual

MDS 05-6399A01, Rev. G MDS™ Master Station 31
Table 5-1. CLI Quick Reference Table
If you wish to... Enter this CLI command:
Create a bridge
% set interfaces interface
bridge
type bridge
Add the ETH1 interface to a
bridge
% set interfaces interface bridge bridge-settings members port eth-0/0/0
Remove the ETH1 interface
from a bridge
% delete interfaces interface bridge bridge-settings members port eth-
0/0/0
View LNMS settings
> show con
figuration interfac
es interface
lnms
ln
-
config
Monitor LNMS Status
(RSSI,EVM, etc)
> show interfaces-state interface lnms ln-status | repeat 5
NOTE: pressing ctrl-c will abort this command
Configure LNMS
Frequencies
% set interfaces interface lnms ln-config rx-frequency <value>
and/or
% set interfaces interface
ln
ms
ln
-
config
tx
-
frequency
<value>
Configure LNMS Radio
Power
% set interfaces interface lnms ln-config power <value>
View SDMS Settings
> show configuration interfaces interface
sdms
sd
-
config
Monitor SDMS Status (RSSI,
SNR, etc)
> show interfaces-state interface sdms sd-status | repeat 5
NOTE: pressing ctrl-c will abort this command
Configure SDMS
Frequencies
% set interfaces interface sdms sd-config radio-config basic-config
receive-frequency <value>
and/or
% set interfaces interface sdms sd-config radio-config basic-config
transmit
-
frequency
<value>
Configure SDMS Modem % set interfaces interface sdms sd-config radio-config basic-config
modem
-
type
<modem>
Configure the SDMS Radio
Mode
% set interfaces interface sdms sd-config radio-config basic-config
radio
-
mode
<radio mode>
Configure SDMS Radio
Power
% set interfaces interface sdms sd-config radio-config basic-config rf-
output
-
power
<value>
Key/Dkey the SDMS Radio > request interfaces interface sdms sd-config maintenance rf-key-test
key radio true/false
Send a Remote Maintenance
Request to Remotes
> request interfaces interface sdms sd-config maintenance remote-
management
-
command
<command name> <value>
View the routing table
> show routing
View the event log
> show table logging event
-
log
Set the admin user’s
password
> request system authentication change-password user admin
password
admin1234
Set the device name
% set system name “
Mydevice
”
Set the baud rate on COM1
% set services serial ports
COM1
b
aud
-
rate
b19200
Download a firmware
package from TFTP server at
192.168.1.10
> request system firmware reprogram-inactive-image filename sdms-
bkrc-1_0_0.mpk manual-file-server { tftp { address 192.168.1.10 } }
Monitor firmware download
status
> show system firmware reprogramming-status
Export configuration file to a
TFTP server at 192.168.1.10
> request system configuration-files export filename myConfig.xml
manual
-
file
-
server {tftp {address
192.168.1.10
} }