Users Manual

46 MDS™ Master Station MDS 05-6399A01, Rev. G
Figure 5-3. System ID Example — Valid Arrangement
Figure 5-4. System ID Example — Invalid Arrangement
• FCC Part 90 Repeater Mode – Repeater mode must be set to one of the following
values:
- None – This is the default value, and is used when the Master Station being con-
figured is not to be used as a repeater in the network.
- Repeater – This value should be selected when the Master Station being config-
ured is to be installed as a repeater in the network, and will not have devices con-
nected to it that will be polled, such as attached RTUs.
- Repeater With Local Data – This is the same as “Repeater” but should be used
when data-collection devices such as serial RTUs will be attached directly to the
repeating Master Station.