Users Manual

MDS 05-6399A01, Rev. G MDS™ Master Station 49
- Serial Port — This setting determines which serial port to use COM1 or COM2.
This must be different than the serial payload port.
• TCP Mode Settings:
- Security Mode – When set to a value other than none, connections will be en-
crypted using a pre-shared key via TLS. The version specified by this parameter
will be only version allowed by the server.
- TCP Port – The TCP port that the Dlink service will listen on.
- IPv4 Addr – Optionally configure the service to only attach to the specified IPv4
Address. This is useful when traffic is being separated into data and management
VLANs. If no value is specified, the service will accept connections on all config-
ured IP addresses.
- IPv6 Addr – Optionally configure the service to only attach to the specified IPv6
Address. This is useful when traffic is being separated into data and management
VLANs. If no value is specified, the service will accept connections on all config-
ured IP addresses.
• Enabled – Enable or disable diagnostics functionality. Setting it to ON configures the
radio to pass the diagnostic link protocol (DLINK) over the radio’s COM2 management
port.
MAC Settings
When operating in packet with MAC mode, MAC specific settings can be configured here.
• Device Type – The role this device will be performing in the network. If this device is
operating as a repeater, the MAC device type MUST be 'remote'.