Users Manual

88 MDS™ Master Station MDS 05-6399A01, Rev. G
mode.
To create the “pipes” that direct data to the desired ports, a route must be established using the
payload serial settings on the general configuration menu for serial data. The default setting is to
listen to all channels. The Talk on parameter is used to specify the VRC used for sending the
data stream over the air, while the Listen to parameter specifies the VRC(s) for incoming data.
Any combination of the three VRC numbers may be entered in the selection fields. Figure 5-2.
Virtual Radio Channel (VRC) Concept illustrates the relationship between the VRC settings and
the routing of data between units.
Figure 5-5. Virtual Radio Channel (VRC) Concept
Important Notes and Information Regarding EVM
x Rx Modulation - The modulation measured at the time of the last received packet.