User's Manual

MDS 05-6399A01, Rev. D MDS Master Station 43
lecting and applying a static NAT rule-set (from available static nat rule-sets) to incoming and
outgoing traffic on this interface.
• Eth Phy Rate - Choose the Ethernet speed support setting (DEFAULT ALL)
• Eth 10Mb Half
• Eth 10Mb Full
• Eth 100Mb Half
• Eth 100Mb Full
• Vlan Mode - Virtual LAN Setting. (VLAN Operation): Valid Choices
• None (DEFAULT)
• Access - Use this if this interface is intended to be a member of only a single VLAN.
• Trunk - Use this if this interface is intended to be a member of multiple VLANs.
Using the CLI, the following sequence shows how to configure the
ETH1 port to obtain a dynamic IPv4
address using DHCP:
> configure
Entering configuration mode private
% set interfaces interface eth-0/0/0 ipv4 dhcp
% commit
NOTE
Before configuring a new IP address, be sure to remove the previous address by issuing the command
% delete interfaces interface eth-0/0/0 ipv4
The following sequence shows how to configure the ETH1 port with a static IPv4 address:
> configure
Entering configuration mode private
% set interfaces interface eth-0/0/0 ipv4 address 192.168.1.11 prefix-length 24
% commit
Monitoring
Ensure the CLI is in Operational mode. Follow the example below to view the state and statistics of the
ETH1 port:
> show interfaces-state interface eth-0/0/0
interfaces-state interface eth-0/0/0
type ethernet
admin-status up
oper-status up
if-index 3
phys-address 00:06:3d:07:96:82
statistics discontinuity-time 2014-02-12T14:29:35-05:00