User's Manual

MDS 05-4121A01, Rev. 02 TRM SB Integration Guide 13

2.1 Mounting the Transceiver

Figure 5 shows the mounting dimensions of the transceiver PC board.

The board should be secured to the mounting surface using the holes

provided at each corner of the assembly. (Fasteners are not supplied.)

Invisible place holder

Figure 5. Transceiver Mounting Dimensions

2.2 Interface Requirements

It is highly desirable to provide for electronic access to the TRM SB

module after it is installed in your product or system. This allows for

module configuration and control, frequency changes when needed,

antenna system optimization, and diagnostic activities.

In addition, it would be beneficial to provide field service personnel a

technique for directly monitoring the test and diagnostic indicators

produced by the unit to indicate the incoming radio signal strength

(RSSI), and the radio synthesizer’s unfiltered out-of-lock indicator.

.140

0.000

2.47

2.61

.140

1.555

1.695

2.750

1.835

2.33

.140

Data

Connector

.090"

.050"

.010

.775

2.465

1.110

.090

.050