User's Manual
Table Of Contents
- Copyright Notice
- Serviceability of this Manual
- Operational Safety Notices
- FM/UL/CSA Notice MDS iNet 900 When Approved
- FM/UL/CSA Conditions of Approval MDS iNet 900 When Approved
- FCC Notice, U.S.A. MDS iNet 900 When Approved
- FCC Information
- 1.0 ABOUT THIS MANUAL
- 2.0 PRODUCT DESCRIPTION
- 3.0 INSTALLATION PLANNING
- 4.0 INSTALLATION
- 4.1 Step 1— Mounting the Transceiver
- 4.2 Step 2—Install the Antenna and Feedline
- 4.3 Step 3—Connect the Data Equipment
- 4.4 Step 4—Measure & Install Primary Power
- 4.5 Step 5—Review the Radio’s Configuration
- 4.6 Step 6—Connect the User Data Equipment
- 4.7 Step 7—Check for Normal Operation
- 4.8 Performance Optimization
- 5.0 TRADITIONAL REPEATER CONFIGURATION WITH TWO RADIOS
- 6.0 PROGRAMMING
- 7.0 TROUBLESHOOTING
- 8.0 REPEATER ASSITED LANS
- 9.0 TECHNICAL REFERENCE
- 10.0 GLOSSARY OF TERMS
- IN CASE OF DIFFICULTY...
10 MDS iNet 900 Installation Guide MDS 05-2873A01, Rev. A
DRAFT 6—8/29/01
Invisible place holder
Figure 5. Omnidirectional antenna for iNet 900 transceiver
Invisible place holder
Figure 6. Omnidirectional antenna for
iNet 900 transceiver (mounted to mast)
At Station Adapter sites and units in point-to-point LANs, a directional
Yagi (Figure 7) antenna is generally recommended to minimize interfer-
ence to and from other users. Antennas are available from a number of
manufacturers.
Invisible place holder
Figure 7. Typical Yagi antenna (mounted to mast)